Rikon Power Tools 60-150 Manuel du propriétaire

60-150www.rikontools.com60-150M21.5 HP Dust Collector Operator’s ManualRecord the serial number and date of purchase in your manual for future referen

10INSTALL STRAP CLAMP IN FILTER BAG1. Unfold and lay the cloth lter bag on a at surface.2. Locate the slit on the right side of the lip of the bag

11ASSEMBLYMOUNTING THE ‘Y’ INLET1. Slide the ‘Y’ inlet over the large 5” opening on the fan housing, so that the three mounting holes align.2. Secur

12PARTS DIAGRAM12345678910111213141516171819202122 232425 262728293031323334333537 3839 40 41 42 43 444546474849 50 51523653NOTE: Please reference the

13PARTS LIST123456789101112131415161718192021222324252627Upper cloth dust bagUpper bag supportFlat washerHexagon bolt M8X16Hose clamp5” Extension hose

WIRING DIAGRAM This machine must be grounded. Replacement of the power supply cable should only be

15WARRANTYMAINTENANCE Turn the power switch “OFF” and disconnect the plug from the outlet prior to adjusting or maintaining the machine. DO NOT attemp

www.rikontools.com60-150M260-150For more information:16 Progress RoadBillerica, MA 01821877-884-5167 / [email protected]

Specications ...2Safety Wa

SAFETY SYMBOLSIMPORTANT! Safety is the single most important consideration in the operation of this equipment. The following instructions must be foll

SAFETY INSTRUCTIONS 16. NEVER LEAVE A RUNNING TOOL UNATTENDED. Turn the power switch to the “OFF” po

THIS SYMBOL DESIGNATES THAT THIS TOOL IS LISTED BY THE INTERTEK TESTING SERVICES, TO UNITED STATES AND CANADIAN STANDARDS. SA

6SPECIFIC SAFETY INSTRUCTIONS FOR DUST COLLECTORSSAFETY INSTRUCTIONSCALIFORNIA PROPOSITION 65 WARNING: Some dust created by power sanding, sawing, gri

When unpacking, check to make sure the following parts are included. If any parts are missing or broken, please call RIKON Power Tools (877-884-5167)

FIG. 1FIG. 28INSTALL THE CASTERS ON THE BASE PLATELocate the four swivel casters, eight 12MM at washers, four star lock washers and four 12MM hex cap

9FIG. 6FIG. 7FIG. 5FIG. 4INSTALL THE 5” OUTLET AND RUBBER GASKETLocate the 5” plastic outlet, rubber gasket, six M6X-20MM hex bolts, twelve 6MM washer