Rikon Power Tools 30-230 Manuel de l'opérateur

www.rikontools.com30-230M3Operator’s ManualRecord the serial number and date of purchase in your manual for future reference.Serial Number: __________

INSTALLING THE TABLE1. Install the locking lever onto the table support bracket then insert the table post (A-Fig. 11) into the table support bracket

11Disconnect machine from the power source.WARNING! 1. Turn off and disconnect the power to the Drill Press.2. Open belt cover.3. Release the loc

12SETTING THE SPINDLE LOCK 1. Loosen the depth stop collar lock (A-Figure.16). 2. Lower the spindle to the desired depth. (Figure.17)3. Turn the depth

Maintenance To avoid injury due to unexpected starting, before cleaning or carring out maintenance work, switch off and discon

Electrical RequirementsIn the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the ri

15TroubleshootingTROUBLE PROBABLE CAUSE REMEDYNoisy Operation 1. Incorrect belt tension. 1. Adjust tension.2. Dry Spindle. 2. Lubricate spindle.3. Loo

16Parts Explosion

17Parts Explosion17

Parts Explosion18

DescriptionHex. socket set screwCollar-RackGear-HelicalCrankTableClamp-TableHex. head screwArm-table w/scaleBaseSupport ColumnHex. head screwHex. sock

Operator Safety: Required ReadingIMPORTANT! Safety is the single most important consideration in the operation of this equipment. The following instr

20Notes

30-230M3

ALWAYS CHECK FOR DAMAGED PARTS.Before initial or continual use of the tool, a guard or other part that is damaged should be checked to assure that it

Safety Warnings...2-3

Model 30-230 17” Floor Drill Press is shipped complete in one box.Unpacking and Checking Contents a. Separate all “loose parts” from packaging materia

6Getting to Know Your Drill PressBelt CoverFeed HandleTableTable SupportBaseMotorCrank HandleLock HandleSwitchChuckLock HandleLock HandleColumnColumn

7Base and Column Assembly1. Place the base (A-Fig. 1) on a level oor where the machine will be used.2. Attach the column (B-Fig.1) to the base

84. Install the idler pulley and drive belts. Simply slide the pivot post of the idler pulley into the corresponding hole in the drill press head. T

9INSTALLING/REMOVING CHUCK It is important that the chuck and arbor are free of any grease or rust protection. Use ordinary h